Entryway Cubbies Ideas

Posted on

Entryway cubbies have a dual purpose. You can store shoes in it and use it as a place to sit. When building one, you must consider both of these uses. The bench must be long enough to store a pair of shoes and also need enough height for a comfortable seat height. This bench is easy enough for someone just started doing some woodworking. If you have any experience, this will only take a couple of hours to do. This bench can be as decorative or simple as you wish.

Instructions

Measure 16 inches, twice, on a number 1-by-10. Use a straight edge to mark this measurement across the board. Measure 24 inches on the same card and use a straight edge to mark this measurement across the board. Cut the board in this direction. These boards will be the two sides and the shelf. Lay side boards flat on the ground. Place a coffee can partially on the bottom of each board. You will cut out the trace around the can to make the entryway cubbies. Each foot should be about 1 1/2 inches wide, so the center can be proper to get this measurement on both sides. Trace around the can, on both boards, and cut the section out with a saber saw.

Smooth the cut you just made with 120 grit sandpaper. Measure 20 1/2 inches on a 1-by-4, three times. Cut the board along these measurements. When play becomes the base, you will come to the ramp entryway cubbies. Place an oak stairway on the floor, upside down. Place the edge of the ramp on the front part of the stairway and cleat the edge of the spine. Place the two sides against the side edges apron and button. Secure the sides of the site with finishing nails. Remove the sides from the tread staircase. Measure and cut the tread to 24 inches long. Lay it flat on the ground, upside down.

See also  Choosing Modern Entryway

Apply a string of trousers to the top edges of the tabs and apron pages. Place this part of the entryway cubbies up and down the underside of the stairs. Secure it with some finishing nails. Turn the bench right side up. Measure 3 inches from the bottom of both sides and mark with a pen. Place the shelf piece on this level. Use a level to make sure the bench is sitting flat. Nail the shelf in place with finishing nails. Place the base piece under the shelf. The top edge of the base piece should be flat against the bottom of the shelf. Nail the base in place with finishing nails. Sand the project smoothly with 120 grit sandpaper. Prime sides, shelf, base and apron. Paint the project color of your choice.